Senate Bill No. 59
(By Senator Foster)
[Introduced January 11, 2012; referred to the Committee on the Judiciary.]
A BILL to amend the Code of West Virginia, 1931, as amended, by adding thereto a new article, designated §16-44-1, §16-44-2, §16-44-3, §16-44-4, §16-44-5, §16-44-6, §16-44-7, §16-44-8 and §16-44-9, all relating to creating the West Virginia Swimming Pool Safety Act; stating purpose; defining terms; establishing required safety features and building requirements for residential swimming pools; setting forth requirements for the Bureau for Public Health; and providing exemptions.
Be it enacted by the Legislature of West Virginia:
That the Code of West Virginia, 1931, as amended, be amended by adding thereto a new article, designated §16-44-1, §16-44-2, §16-44-3, §16-44-4, §16-44-5, §16-44-6, §16-44-7, §16-44-8 and §16-44-9, all to read as follows:
ARTICLE 43. WEST VIRGINIA SWIMMING POOL SAFETY ACT.
§16-44-1. Short title.
This article may be known and cited as the “West Virginia Swimming Pool Safety Act.”
This article is intended to enhance the safety of residential pools and spas; encourage the use of layers of protection; prevent child drowning in pools and spas; reduce the number of suction entrapment incidents, injuries and deaths; and educate the public on the importance of constant supervision of children in and around water.
As used in this article:
(1) "Approved safety pool cover" means a manually or power-operated safety pool cover that meets all of the performance standards of the American Society for Testing and Materials (ASTM),
in compliance with standard F 1346-91.
(2) "Enclosure" means a fence, wall or other barrier that isolates a swimming pool from access to the home.
(3) "Exit alarms" means devices that make audible, continuous
alarm sounds when any door or window, that permits access from the
residence to the pool area that is without any intervening enclosure, is opened or is left ajar. Exit alarms may be battery operated or may be connected to the electrical wiring of the building.
(4) "Public swimming pool" means a swimming pool operated for the use of the general public with or without charge, or for the use of the members and guests of a private club. Public swimming pool does not include a swimming pool located on the grounds of a private single-family home.
(5) "Swimming pool" or "pool" means any structure intended for
swimming or recreational bathing that contains water over eighteen inches deep. "Swimming pool" includes in-ground and above-ground structures and includes, but is not limited to, hot tubs, spas, portable spas and nonportable wading pools.
§16-44-4. Required safety features.
(a) Beginning July 1, 2012, except as provided in section eight of this article, whenever a building permit is issued for construction of a new swimming pool or spa, or any building permit is issued for remodeling of an existing pool or spa, at a private, single-family home, the permit shall require that the pool or home, as applicable, be equipped with at least one of the following drowning prevention safety features:
(1) By isolating the pool from access to the home by an enclosure that meets the requirements of section five of this article;
(2) By incorporating a removable mesh pool fencing that meets American Society for Testing and Materials (ASTM) Specifications F 2286 standards in conjunction with a gate that is self-closing and self-latching and can accommodate a key lockable device;
(3) By equipping the pool with an approved safety pool cover that meets all requirements of the ASTM Specifications F 1346;
(4) By equipping the home with exit alarms on those doors providing direct access to the pool;
(5) By providing that all doors allowing direct access from the home to the swimming pool are equipped with a self-closing, self-latching device with a release mechanism placed no lower than fifty-four inches above the floor;
(6) By installing swimming pool alarms that when placed in the pool sound upon detection of accidental or unauthorized entrance into the water, if the alarms meet and are independently certified to the ASTM Standard F 2208 "Standards Specification for Pool Alarms" including surface motion, pressure, sonar, laser, and infrared type alarms, but not swimming protection alarm devices that are designed for individual use, such as an alarm attached to a child that sounds when the child exceeds a certain distance or becomes submerged in water; or
(7) By installing other means of protection, if the degree of the protection afforded is equal to or greater than that afforded by any of the devices set forth above, and have been independently verified by an approved testing laboratory as meeting standards for those devices established by the ASTM or the American Society of Mechanical Engineers (ASME).
(b) Prior to the issuance of any final approval for the completion of permitted construction or remodeling work, the local building code official shall inspect the drowning safety prevention devices required by this article and if no violations are found, shall give final approval.
§16-44-5. Enclosure requirements.
An enclosure must meet all of the following characteristics:
(1) Any access gates through the enclosure open away from the
swimming pool, and are self-closing with a self-latching device placed no lower than sixty inches above the ground;
(2) A minimum height of sixty inches;
(3) A maximum vertical clearance from the ground to the bottom of the enclosure of two inches;
(4) Gaps or voids, if any, that do not allow passage of a sphere equal to or greater than four inches in diameter; and
(5) An outside surface free of protrusions, cavities or other
physical characteristics that would serve as handholds or footholds
that could enable a child below the age of five years to climb over.
§16-44-6. Building permit requirements.
(a)(1) Whenever a building permit is issued for the construction of a new swimming pool or spa, the pool or spa must meet all of the following requirements:
(A) The suction outlet of the pool or spa for which the permit is issued must be equipped to provide circulation throughout the pool or spa as prescribed in subdivision (2) of this subsection; and
(B) The swimming pool or spa must have at least two circulation drains per pump that are hydraulically balanced and symmetrically plumbed through one or more "T" fittings, and that are separated by a distance of at least three feet in any dimension between the drains.
(2) Suction outlets that are less than twelve inches across must be covered with antientrapment grates, as specified in the ASME/ANSI Standard A 112.19.8, that cannot be removed except with the use of tools. Slots or openings in the grates or similar protective devices must be of a shape, area, and arrangement that prevent physical entrapment and do not pose any suction hazard to bathers.
(3) Any backup safety system that an owner of a new swimming pool or spa chooses to install in addition to the requirements set forth in subdivisions (1) and (2) of this subsection must meet the standards as published in the document, "Guidelines for Entrapment Hazards: Making Pools and Spas Safer," Publication Number 363, March 2005, United States Consumer Product Safety Commission.
(b) Whenever a building permit is issued for the remodel or modification of an existing swimming pool, toddler pool, or spa, the permit shall require that the suction outlet of the existing swimming pool, toddler pool or spa be upgraded so as to be equipped with an antientrapment cover meeting current standards of the American Society for Testing and Materials (ASTM) or the American Society of Mechanical Engineers (ASME).
§16-44-7. Notice to consumers.
(a) Any person entering into an agreement to build a swimming pool or spa, or to engage in permitted work on a pool or spa covered by this article, shall give the consumer notice of the requirements of this article.
(b) The Bureau for Public Health shall make available on it’s web site, beginning July 1, 2012, approved pool safety information available for consumers to download. Pool contractors are encouraged to share this information with consumers regarding the potential dangers a pool or spa poses to toddlers. Additionally, pool contractors may provide the consumer with swimming pool safety materials produced from organizations such as the United States Consumer Product Safety Commission, Drowning Prevention Foundation, California Coalition for Children's Safety & Health, Safe Kids Worldwide, Association of Pool and Spa Professionals or the American Academy of Pediatrics.
This article does not apply to any of the following:
(1) Public swimming pools;
(2) Hot tubs or spas with locking safety covers that comply with the American Society for Testing Materials-Emergency Performance Specification (ASTM-ES 13-89);
(3) Any pool within the jurisdiction of any political subdivision that adopts an ordinance for swimming pool safety that includes requirements that are at least as stringent as this article; and
(4) An apartment complex, or any residential setting other than a single-family home.
§16-44-9. Federal grant assistance.
The Bureau for Public Health shall seek a federal grant from the Consumer Product Safety Commission as provided by Section 1405 of the Virginia Graeme Baker Pool and Spa Safety Act (15 U.S.C. § 8004) to assist in its implementation of this article.
NOTE: The purpose of this bill is to create the West Virginia Pool Safety Act. The bill states it’s purpose to enhance the safety of private swimming pools and prevent child drownings. The bill also defines terms. The bill establishes required safety features and building requirements for private swimming pools. The bill sets forth requirements for the Bureau for Public Health and for it to seek available federal grants. The bill also provides exemptions.
This article is new; therefore, strike-throughs and underscoring have been omitted.