§47-5-2. Labeling required.
(a) Each light of safety glazing material manufactured,
distributed, imported or sold for use in hazardous locations or
installed in a hazardous location within this state shall be
permanently labeled by such means as etching, sandblasting or
firing ceramic material on the safety glazing material. The
label shall identify the labeler, whether manufacturer,
fabricator or installer, the thickness and type of safety glazing
material, and the fact that the material meets the test
requirements of American National Standards Institute Standard Z-
97.1-1966 and any further requirements as may be adopted by the
department of labor. The label must be legible and visible after
installation.
(b) Safety glazing labeling shall not be used on other than
safety glazing materials.