H. B. 4348
(By Delegate Manypenny)
[Introduced January 30, 2012; referred to the
Committee on the Judiciary then Finance.]
A BILL to amend and reenact §22-6A-7 of the Code of West Virginia, 1931, as amended, relating to revocation of current and future horizontal well permits when a driller or well operators violates conditions or road bonds or other well pad and site operating requirements.
Be it enacted by the Legislature of West Virginia:
That §22-6A-7 of the Code of West Virginia, 1931, as amended, be amended and reenacted to read as follows:
ARTICLE 6A. NATURAL GAS HORIZONTAL WELL CONTROL ACT.
§22-6A-7. Horizontal well permit required; permit fee; application; soil erosion control plan; well site safety plan; site construction plan; water management plan; permit fee; installation of permit number; suspension revocation and denial of a permit.
(a) It is unlawful for any person to commence any well work, including site preparation work which involves any disturbance of land, for a horizontal well without first securing from the secretary a well work permit pursuant to this article.
(b) Every permit application filed under this section shall be on a form as may be prescribed by the secretary, shall be verified and shall contain the following information:
(1) The names and addresses of: (i) The well operator; (ii) the agent required to be designated under subsection (h) of this section; and (iii) every person whom the applicant shall notify under any section of this article, together with a certification and evidence that a copy of the application and all other required documentation has been delivered to all such persons;
(2) The names and addresses of every coal operator operating coal seams under the tract of land on which the well is or may be located, and the coal seam owner of record and lessee of record required to be given notice by subdivision (6), subsection (a), section five of this article, if any, if said owner or lessee is not yet operating said coal seams;
(3) The number of the well or such other identification as the secretary may require;
(4) The well work for which a permit is requested;
(5) The approximate total depth to which the well is to be drilled or deepened, or the actual depth if the well has been drilled; the proposed angle and direction of the well; the actual depth or the approximate depth at which the well to be drilled deviates from vertical, the angle and direction of the nonvertical well bore until the well reaches its total target depth or its actual final depth and the length and direction of any actual or proposed horizontal lateral or well bore;
(6) Each formation in which the well will be completed if applicable;
(7) A description of any means used to stimulate the well;
(8) If the proposed well work will require casing or tubing to be set, the entire casing program for the well, including the size of each string of pipe, the starting point and depth to which each string is to be set and the extent to which each such string is to be cemented;
(9) If the proposed well work is to convert an existing well, all information required by this section, all formations from which production is anticipated and any plans to plug any portion of the well;
(10) If the proposed well work is to plug or replug the well, all information necessary to demonstrate compliance with the legislative rules promulgated by the secretary in accordance with section thirteen of this article;
(11) If the proposed well work is to stimulate a horizontal well, all information necessary to demonstrate compliance with the requirements of subdivision (7), subsection (a), section five of this article;
(12) The erosion and sediment control plan required under subsection (c) of this section for applications for permits to drill;
(13) A well site safety plan to address proper safety measures to be employed for the protection of persons on the site as well as the general public. The plan shall encompass all aspects of the operation, including the actual well work for which the permit was obtained, completion activities and production activities, and shall provide an emergency point of contact for the well operator. The well operator shall provide a copy of the well site safety plan to the local emergency planning committee established pursuant to section seven, article five-a, chapter fifteen of this code, for the emergency planning district in which the well work will occur at least seven days before commencement of well work or site preparation work that involves any disturbance of land;
(14) A certification from the operator that: (i) It has provided the owners of the surface described in subdivisions (1), (2) and (4), subsection (b), section ten of this article, the information required by subsections (b) and (c), section sixteen of this article; (ii) that the requirement was deemed satisfied as a result of giving the surface owner notice of entry to survey pursuant to subsection (a), section ten of this article; or (iii) the notice requirements of subsection (b), section sixteen of this article were waived in writing by the surface owner; and
(15) Any other relevant information which the secretary may reasonably require.
(c)(1) An erosion and sediment control plan shall accompany each application for a well work permit under this article. The plan shall contain methods of stabilization and drainage, including a map of the project area indicating the amount of acreage disturbed. The erosion and sediment control plan shall meet the minimum requirements of the West Virginia Erosion and Sediment Control Manual as adopted and from time to time amended by the department. The erosion and sediment control plan shall become part of the terms and conditions of any well work permit that is issued pursuant to this article and the provisions of the plan shall be carried out where applicable in the operation. The erosion and sediment control plan shall set out the proposed method of reclamation which shall comply with the requirements of section fourteen of this article.
(2) For well sites that disturb three acres or more of surface, excluding pipelines, gathering lines and roads, the erosion and sediment control plan submitted in accordance with this section shall be certified by a registered professional engineer.
(d) For well sites that disturb three acres or more of surface, excluding pipelines, gathering lines and roads, the operator shall submit a site construction plan that shall be certified by a registered professional engineer and contains information that the secretary may require by rule.
(e) In addition to the other requirements of this section, if the drilling, fracturing or stimulating of the horizontal well requires the use of water obtained by withdrawals from waters of this state in amounts that exceed two hundred ten thousand gallons during any thirty day period, the application for a well work permit shall include a water management plan, which may be submitted on an individual well basis or on a watershed basis, and which shall include the following information:
(1) The type of water source, such as surface or groundwater, the county of each source to be used by the operation for water withdrawals, and the latitude and longitude of each anticipated withdrawal location;
(2) The anticipated volume of each water withdrawal;
(3) The anticipated months when water withdrawals will be made;
(4) The planned management and disposition of wastewater after completion from fracturing, refracturing, stimulation and production activities;
(5) A listing of the anticipated additives that may be used in water utilized for fracturing or stimulating the well. Upon well completion, a listing of the additives that were actually used in the fracturing or stimulating of the well shall be submitted as part of the completion log or report required by subdivision (14), subsection (a), section five of this article;
(6) For all surface water withdrawals, a water management plan that includes the information requested in subdivisions (1) through (5) of this subsection and the following:
(A) Identification of the current designated and existing water uses, including any public water intakes within one mile downstream of the withdrawal location;
(B) For surface waters, a demonstration, using methods acceptable to the secretary, that sufficient in-stream flow will be available immediately downstream of the point of withdrawal. A sufficient in-stream flow is maintained when a pass-by flow that is protective of the identified use of the stream is preserved immediately downstream of the point of withdrawal; and
(C) Methods to be used for surface water withdrawal to minimize adverse impact to aquatic life; and
(7) This subsection is intended to be consistent with and does not supersede, revise, repeal or otherwise modify articles eleven, twelve or twenty-six of this chapter and does not revise, repeal or otherwise modify the common law doctrine of riparian rights in West Virginia law.
(f) An application may propose and a permit may approve two or more activities defined as well work, however, a separate permit shall be obtained for each horizontal well drilled.
(g) The application for a permit under this section shall be accompanied by the applicable bond as required by section fifteen of this article, the applicable plat required by subdivision (6), subsection (a), section five of this article and a permit fee of $10,000 for the initial horizontal well drilled at a location and a permit fee of $5,000 for each additional horizontal well drilled on a single well pad at the same location.
(h) The well operator named in the application shall designate the name and address of an agent for the operator who is the attorney-in-fact for the operator and who is a resident of the State of West Virginia upon whom notices, orders or other communications issued pursuant to this article or article eleven of this chapter may be served, and upon whom process may be served. Every well operator required to designate an agent under this section shall, within five days after the termination of the designation, notify the secretary of the termination and designate a new agent.
(i) The well owner or operator shall install the permit number as issued by the secretary and a contact telephone number for the operator in a legible and permanent manner to the well upon completion of any permitted work. The dimensions, specifications, and manner of installation shall be in accordance with the rules of the secretary.
(j) The secretary may waive the requirements of this section and sections eight, ten, eleven and twenty-four of this article in any emergency situation, if the secretary deems the action necessary. In such case the secretary may issue an emergency permit which is effective for not more than thirty days, unless reissued by the secretary.
(k) The secretary shall deny the issuance of a permit if the secretary determines that the applicant has committed a substantial violation of violated a condition of a previously posted road bond or a requirement of a previously issued permit for a horizontal well, including the applicable erosion and sediment control plan associated with the previously issued permit, or a substantial violation of one or more of the rules promulgated under this article, and in each instance has failed to abate or seek review of the violation within the time prescribed by the secretary pursuant to the provisions of subdivisions (1) and (2), subsection (a), section five of this article and the rules promulgated hereunder, which time may not be unreasonable.
(l) In the event the secretary finds that a substantial violation has occurred and that the operator has failed to abate or seek review of the violation in the time prescribed, the secretary may suspend the permit on which said violation exists, after which suspension the operator shall forthwith cease all well work being conducted under the permit. However, the secretary may reinstate the permit without further notice, at which time the well work may be continued. In the event a driller or well operator violates conditions of a road bond or other well pad or site operating requirements, the secretary shall revoke the current permit and deny all future permits. The secretary shall make written findings of any such suspension revocation or denial and may enforce the same in the circuit courts of this state. The operator may appeal a suspension revocation or denial pursuant to the provisions of subdivision (23), subsection (a), section five of this article. The secretary shall make a written finding of any such determination.
NOTE: The purpose of this bill is to require revocation of permit and denial of future permits in the event a driller or well operator violates conditions of a road bond or well pad or site operating requirements.
Strike-throughs indicate language that would be stricken from the present law, and underscoring indicates new language that would be added.